Phoenix Modular switch head station 10/100Mbps Uživatelský manuál Strana 79

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 266
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 78
Configuration and Diagnostics
6874_en_09 PHOENIX CONTACT 4-7
Firmware
Figure 4-8 "Firmware" menu
Here you can view all information about the current device software (firmware). You can
also update the software/firmware using the Factory Manager.
Firmware update When you click on "Update", the following window appears, which contains information
about the firmware used.
During a firmware update, the current status is shown on the MMS display:
03 - Downloading firmware via the network.
04 - Saving the firmware in the MMS Flash memory.
05 - The new firmware has been saved successfully.
Display goes out.
bo - Device is booting and loading new firmware in the RAM.
Following a firmware update, a reset is executed automatically to activate the new
firmware.
Please make sure that the "TFTP Server" service program is activated in the toolbar.
You can monitor the download in the message window (25%, 50%, 75%, 100%). Always
wait until all the LEDs light up after approximately two minutes and the device is available
again after booting.
Zobrazit stránku 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 265 266

Komentáře k této Příručce

Žádné komentáře